Buchi Pump Module C-605 Manuel d'utilisateur télécharger pdf (Page 24)

5 Putting into operation

24 Pump Combinations Operation Manual, Version E

For the installation of the mixer and the suction tubing, see chapter 5.3.3.

Connection tubing between the separator heads of the pumps:

The ﬁtting and ferrule are attached to both tubing

ends.

Attach one end of the connection tubing to the input

of the lower separator head a and the other into

the output of the upper separator head b.

Remove the right rear separator head cover a from

the lower pump. Remove the two small nubs on

the inside by pushing them towards the inside and

outside. Now press the connection tubing b into

the slit of the open separator head c and replace

the separator head cover a.

Fig. 5.15: Installing the connection tubing between the separator heads of the pumps

For a description on the installation of the connection tubing between the lower separator head and

the mixer, see chapter 5.3.3.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 49 50

Pas de commentaire

Buchi Pump Module C-605 Manuel d'utilisateur Page 24