Buchi Pump Module C-605 Manuel d'utilisateur télécharger pdf (Page 20)

5 Putting into operation

20 Pump Combinations Operation Manual, Version E

Connect the pump module a to the pump control-

ler b via data bus RS-485 by means of the cable

RJ45 d.

c TTL IN/OUT.

Fig. 5.6: Rear connections of pump controller and pump module

The overpressure sensor switches off the pump if the pressure exceeds 10 bar. This maximum pres-

sure of 10 bar cannot be changed. The installation of the overpressure sensor is easy to do and

explained in the following:

Overpressure sensor

Clip the overpressure sensor onto the Pump Module

C-601.

Connect the overpressure sensor to the correspon-

ding connector TTL IN/OUT at the back of the Pump

Controller C-610.

Fig. 5.7: Installing the overpressure sensor

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Pas de commentaire

Buchi Pump Module C-605 Manuel d'utilisateur Page 20