Buchi Pump Module C-605 Manuel d'utilisateur télécharger pdf (Page 18)

5 Putting into operation

18 Pump Combinations Operation Manual, Version E

5.3 Installation

In order to make things clearer, the following descriptions do not contain the complete names of the

modular pump systems, but rather the general name.

Pump Controller C-610: Pump controller

Pump Manager C-615: Pump manager

Pump Module C-601/605: Pump module

Mixer (pressure sensor with integrated mixing chamber): Pressure sensor

Control Unit C-620: Control unit

5.3.1 Installating the standard accessories

Suction tubing 4 mm x 2.5 mm, length 1.5 m

ATTENTION

The pump module may never be operated without the suction ﬁlter, since otherwise impurities may

enter the pump system.

Cut the suction tubing a to the desired length and

fasten it to the suction ﬁlter. Place the ﬁtting b and

the ferrule c on the other end of the suction tubing

a. Attach the ﬁtting b and the ferrule c.

Press the suction tubing a and the ferrule c against

a table surface to ﬁrmly seal the tubing end with

the ferrule.

Fig. 5.1: Installing ﬁtting and ferrule

Remove the protective foil from the input and output

of the pump head. Screw the white ﬁtting b into the

lower input d of the separator head. Make sure that

all ﬁttings are hand-tight. The end of the tubing a

with the solvent ﬁlter goes into the solvent vessel.

Fig. 5.2: Pump head with connected suction tubing

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Pas de commentaire

Buchi Pump Module C-605 Manuel d'utilisateur Page 18