Buchi Scrubber K-415 Manuel d'utilisateur télécharger pdf (Page 28)

5 Putting into operation

28 K-415 Operation Manual, Version B

5.3 Equipping the Scrubber with the condenser unit

To prepare a Scrubber model for operation with a condenser, proceed as follows:

• Unless the carrier-plate a for the condenser is not yet installed, slide it into the housing from the

side and ﬁx it with the two screws from below. The groove b must point away from the opening in

the housing (see ﬁgure 5.5).





Fig. 5.5: Fixing the carrier plate

• Carefully slide the condenser from top into the opening in the housing and ﬁx it on the carrier plate

a with the rubber strap c. The rubber strap has to be passed through the groove on the back-

side of the carrier plate to prevent it from sliding up or down and to guarantee a tight positioning of

the condenser (see arrow in ﬁgure 5.6). Make sure the connections of the condenser are pointing

backward.

• The receiving vessel d can be attached from below and secured with the catchpot clip e.







Fig. 5.6: Fixing the condenser with the rubber strap

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Pas de commentaire

Buchi Scrubber K-415 Manuel d'utilisateur Page 28